Can a finished assembly be tested after the material has been bonded into place?
Last reviewed: .
Can a finished assembly be tested after the material has been bonded into place?
The Terms of Use state that a test of C-POLAR material, a component, or a prototype does not establish the performance of a finished product that incorporates it, and that construction, processing, storage, wear, cleaning, other components, and actual use may change the result.
The Terms of Use state: “A prospective partner or manufacturer must perform its own testing, validation, compatibility work, safety review, risk review, and quality controls for its proposed product and use.” They also state: “Use evidence, specifications, instructions, and warnings specific to the actual finished product and use.” What a finished assembly can be tested for, and how, is decided by the party that makes it. The Terms of Use state: “A reported result describes only what the identified test found.”
For the property itself, the charge is measured on every production run, and the measurement can be repeated on any filter, upon request.
Source: C-POLAR — Terms of Use, sections 3 and 5, https://cpolar.tech/terms/; Statement of Classification for the NanoFlashing™ Air Filter, section 2.3, issued by NF Technical Products Inc.
Reviewed on .
Sources
- C-POLAR — Terms of Use, sections 3 and 5
- Statement of Classification for the NanoFlashing™ Air Filter, section 2.3, issued by NF Technical Products Inc.